General Description - GYS Wattmatic 100 Mode D'emploi

• Warning! Always remove the power plug from the wall socket
before carrying out any work on the device.
• If the internal fuse is blown, it must be replaced by the manufacturer,
its after-sales service or an equally qualified person.
• Regularly take off the cover and remove dust with an air gun. Take
the opportunity to have a qualified person check the electrical
connections with an insulated tool.
• Under no circumstances should solvents or other aggressive
cleaning agents be used.
• Clean the device's surfaces with a soft, dry cloth.
Regulations :
• The device complies with European Directive.
• The certificate of compliance is available on our website.
• EAC conformity mark (Eurasian Economic Commission)
Disposal:
• This product should be disposed of at an appropriate recycling
facility. Do not dispose of in domestic waste.

GENERAL DESCRIPTION

Congratulations for the selection of this product, which has been designed with great care. To get
the best use of it, please read carefully the following instructions. Keep this instruction manual safe,
you may want to read it again later.
WATTMATIC is designed to charge starting liquid or gel electrolyte lead-acid batteries :
- from 15 Ah to 100 Ah in 6V or 12V for the WATTMATIC 100 (3 or 6 2V elements)
- from 20 Ah to 150 Ah in 6V or 12V for the WATTMATIC 140 (3 or 6 2V elements)
- from 25 Ah to 180 Ah in 6V or 12V for the WATTMATIC 170 (3 or 6 2V elements)
Load curve: WUoU. This curve ensures a 100% charge and maintains the level of charge thanks to
Floating.
CONNECTION IN CHARGER FUNCTION
Preliminary precautions
• For indoor use, with good ventilation.
• Remove the battery caps if there is, and check the level of liquid. If it is not correct; filled up with
distilled water. Clean well the battery terminals.
• Check if the battery capacity and voltage are compatible with your charger.
Connection and disconnection
• Connect the clamps (+ red, - black) to + and - battery terminals, making sure you get a good
electric contact, respecting the following order.
▪ Connect first the battery terminal not connected to the chassis of the vehicle.
▪ Then connect the other connection to the chassis remote from the battery and any fuel line.
WATTMATIC 100.140.170
Translation of the original instructions
EN
9