GYS Wattmatic 100 Mode D'emploi page 8

• During the charge, the battery must be placed in a well ventilated
• Avoid flames and sparks. Do not smoke.
• Protect the electrical contacts of the battery against short-circuiting.
Acid projection hazard!
• Wear safety goggles and protective gloves
• If your eyes or skin come into contact with battery acid, rinse the
Connection / disconnection:
• Disconnect the power supply before connecting/disconnecting
• The terminal of the battery that is not connected to the car frame
• After the charging process, disconnect the battery charger from
Connection:
• This device must be connected to an earthed power supply
• Class II device. (WATTMATIC 100)
• This machine is fuse-protected
Connection to the mains must be made according to the national
installation regulations.
Maintenance:
• If the power supply cable is damaged, it must be replaced by the
• Service should be performed by a qualified person
8
WATTMATIC 100.140.170
area.
affected part of the body with plenty of water and seek immediate
medical assistance.
the device to/from the battery
must be connected first. The other connection must be made on
the car frame, far from the battery and the fuel line. The battery
charger must be connected to the power supply network.
the power supply network and remove the connector from the
car frame and then the connector from the battery, in this order.
(WATTMATIC 140 and WATTMATIC 170)
manufacturer, its service agent or an equally qualified person.
Translation of the original instructions
EN