Table des Matières
Publicité
6-3. Troubleshooting
Trouble
Electrode wire feeding stops or feeds er-
ratically during welding.
Motor runs slowly.
Motor runs at full speed regardless of
wire speed setting.
Notes
Readjust hub tension and drive roll pressure.
Change to correct size drive roll.
Clean or replace dirty or worn drive roll.
Incorrect size or worn wire guides.
Replace contact tip or liner. See gun Owner's Manual.
Remove weld spatter or foreign matter from around gun nozzle opening.
Check and secure motor plug connection.
Have Factory Authorized Service Agent check drive motor.
Reduce load.
Check for correct input voltage.
Have Factory Authorized Service Agent check digital wire drive motor Tachometer board and encoder.
Remedy
OM-268183 Page 17
Publicité
Table des Matières
Dépannage
