Noise Tests - Promac SX-823DGSVI Mode D'emploi

This type of blade is the most suitable for the
cutting of section bars and large and thick pipes as
well as for the cutting of solid bars at maximum
machine capacity. Available pitches: 3-4/4-6.
SETS
Saw teeth bent out of the plane of the saw body,
resulting in a wide cut in the workpiece.
REGULAR OR RAKER SET: Cutting teeth right
and left, alternated by a straight tooth.
Of general use for materials with dimensions
superior to 5 mm. Used for the cutting of steel,
castings and hard nonferrous materials.
WAVY SET: Set in smooth waves.

9 NOISE TESTS

The test was held under environmental noise levels of 65db. Noise measurements with the machine
operating unload was 71db. Noise level during the cutting of mild carbon steel was 73db.
NOTE: with the machine operating, the noise level will vary according to the different materials being
processed. The user must therefore assess the intensity and if necessary provide the operators with the
necessary personal protection, as required by Law 277/1991.
This set is associated with very fine teeth and it is
mainly used for the cutting of pipes and thin section
bars (from 1 to 3 mm).
ALTERNATE SET (IN GROUPS): Groups of cutting
teeth right and left, alternated by a straight tooth.
This set is associated with very fine teeth and it is
used for extremely thin materials (less than 1mm).
ALTERNATE SET (INDIVIDUAL TEETH): Cutting
teeth right and left.
This set is used for the cutting of nonferrous soft
materials, plastics and wood.
- 14 -