Grizzly ARM 2433-20 Traduction De La Notice D'utilisation Originale page 25

Working with the Equipment:
Do not place feet or hands
near or under rotating parts
when working. Risk of injury!
• Switch on the motor accord-
ing to the instructions and only
when your feet are at a safe
distance from the cutting tools.
• Do not use the equipment in
the rain, in poor weather, in a
damp environment, or on wet
grass. Work only in daylight or
with good lighting.
• Do not work with the equipment
when tired, lacking concentra-
tion or under the influence of
alcohol or drugs. Always take
breaks in good time. Take a
sensible approach to the work.
• When working, ensure a firm
stance, particularly on slopes.
Always work across the slope,
never upwards or downwards.
Take particular care when
changing the direction of travel
on the slope. Do not work on
excessively steep slopes.
• Run the equipment only at a
walking pace. Take particular
care when turning the equip-
ment around, pulling it towards
you or going backwards.
• Switch on the equipment care-
fully and in accordance with
the directions in these instruc-
tions. Ensure sufficient distance
between feet and the rotating
blades.
• Do not tilt the equipment when
starting other than if it is nec-
essary to do so when starting
up in long grass. In this case,
tilt the equipment by press-
ing down the handle bar such
that the front wheels of the
equipment are raised. Always
check that both hands are in
the working position before
returning the equipment to the
ground.
• Do not work without the grass
box or collision guard. Keep
away from the ejection hole at
all times.
• Do not start the motor when
standing in front of the dis-
charge chute.
Caution! Danger! The
blade continues to run after
switching off. There is a risk
of injury.
• The equipment is not to be
lifted or transported while the
motor is running. Switch off
the equipment if it has to be
tilted in transit, when crossing
surfaces other than grass, and
when the equipment is being
transported to and from the
surfaces to be mowed.
• Always keep the grass ejection
hole clean and clear. Remove
cut material only when the
equipment is stopped.
• Do not leave the equipment
unattended in the workplace.
• Do not work with equipment
that is damaged, incomplete,
or has been modified without
the authorisation of the manu-
facturer. Do not use the equip-
ment with damaged safety
devices or screens or with
GB
25