Grizzly ERM 1846 GT Traduction De La Notice D'utilisation Originale page 25

directions in these instructions.
Ensure sufficient distance bet-
ween feet and the rotating bla-
des.
• Do not tilt the equipment when
starting other than if it is neces-
sary to do so when starting up in
long grass. In this case, tilt the
equipment by pressing down the
handle bar such that the front
wheels of the equipment are
raised. Always check that both
hands are in the working posi-
tion before returning the equip-
ment to the ground.
• Do not work without the grass
bag or collision guard. Keep
away from the ejection hole at all
times.
• Do not start the motor while
standing in front of the discharge
duct.
Caution! Danger! The blade
continues to run after swit-
ching off.
There is a risk of injury.
• The equipment is not to be
lifted or transported while the
motor is running. Switch off the
equipment if it has to be tilted in
transit, when crossing surfaces
other than grass, and when the
equipment is being transported
to and from the surfaces to be
mowed.
• Always keep the grass ejection
hole clean and clear. Remo-
ve cut material only when the
equipment is stopped.
• Do not leave the equipment un-
attended in the workplace.
• Do not work with equipment
that is damaged, incomplete, or
has been modified without the
authorisation of the manufactu-
rer. Do not use the equipment
with damaged safety devices or
screens or with missing safety
equipment such as deflection
and/or grass collection devices.
• Do not overload the equipment.
Work only within the specified
power range and do not change
the regulator settings on the
motor. Do not use low-powered
machines for heavy work. Do
not use your equipment for pur-
poses other than those for which
it is designed.
• Do not use the equipment near
inflammable liquids or gases.
Non-observance will result in a
risk of fire or explosion.
• Do not lift or carry the equipment
when the motor is running.
• Turn off the appliance, unplug it
from the mains and check that
all moving parts are at rest:
- Whenever you leave the ma-
chine,
- Before cleaning the ejection
hole or removing blockages,
- When the equipment is out of
use,
- Before checking, cleaning or
working on the equipment,
- If the power cable is damaged
or frayed,
- If the equipment has hit a for-
eign object or if strange vibra-
tions occur during work. In this
case, check the equipment for
damage and have it repaired if
applicable.
• Do not place feet or hands near
or under rotating parts. Do not
stand in front of the grass ejec-
tion hole during sickle mowing.
GB
25