Level Gauge; Working With The Lawnmower; Cleaning/Maintenance; General Cleaning And Maintenance Work - Grizzly ERM 1846 GT Traduction De La Notice D'utilisation Originale

6. To switch off , re-
lease the start lever
(2).
After switching off the equip-
ment, the blade continues to
turn for several seconds. Do not
touch the moving blade. There
is a risk of injury.

Level gauge

The level gauge (
the side of the grass catcher (
aerodynamic air guidance provided by the
fl ap also optimises the fi lling.
Flap open:
grass catcher empty
Flap closed:
grass catcher full

Working with the Lawnmower

Regular mowing encourages increased
foliation of the grass and kills off weeds at
the same time. Therefore, not only does
each mowing increase the density of the
lawn, it also produces an evenly resilient
lawn.
When mulch mowing the grass is cut in
one cycle, fi nely chopped and distributed
on the lawn. The cut grass acts as a natu-
ral fertilizer.
Mowing a lawn with a lateral grass ejec-
tion point is suitable for larger surfaces.
The clippings are ejected from the side
and can subsequently be collected manu-
ally in one cycle.
• Start mowing near the socket and
work away from the socket.
• Always keep the extension cable be-
hind you and when you turn, move it to
STOP
3
16) is located on
7). The
the side that has already been mowed.
START
• Run the equipment at a walking pace,
1
I
in tracks that are as even as possible.
2
For gap-free mowing, the tracks should
always overlap by a few centimetres.
• Adjust the cut height so the equipment
is not overloaded. Otherwise, the mo-
tor may be damaged.
• On slopes, always work across the
slope. Take particular care when going
backwards and pulling the equipment.
• Clean the equipment after each use,
as described in the chapter on "Clean-
ing, Maintenance and Storage".
Switch off the equipment after work
and in order to transport it, discon-
nect the plug and wait until the
blade stops. There is a risk of injury.

Cleaning/Maintenance

Have work that is not described
in these instructions carried out
by a customer service centre
that we have authorised. Use
only original parts.
Wear gloves when handling the
blade.
Switch off the equipment before all
maintenance and cleaning work,
disconnect the plug and wait until
the blade stops.
General Cleaning and
Maintenance Work
Do not hose down the lawnmow-
er with water. This would result
in the danger of an electric
shock and the appliance could
be damaged.
GB
29