Replacement Parts/Accessories - Grizzly ERM 1637 G Traduction De La Notice D'utilisation Originale

GB
This device is designed for operation on
a power supply network with a system
impedance Z at the transfer point
max
(domestic connection) of a maximum of
0.313 Ohms.
The user must ensure that the device is
operated only on a power supply network
that fulfils this requirement.
If necessary, the local power supply com-
pany can be asked for the system imped-
ance.
The stated vibration emission value was
measured in accordance with a standard
testing procedure and may be used to
compare one power tool to another.
The stated vibration emission value may
also be used for a preliminary exposure
assessment.
Warning: The vibration emission
value may differ during actual use
of the power tool from the stated
value depending on the manner in
which the power tool is used.
Safety precautions aimed at pro-
tecting the user should be based
on estimated exposure under
actual usage conditions (all parts
of the operating cycle are to be
considered, including, for example,
times during which the power tool is
turned off and times when the tool
is turned on but is running idle).
30
The noise and vibration values have been
determined in accordance with the stand-
ards and regulations specified in the dec-
laration of conformity.
Technical and visual modifications may
be made without notice in the course
of further development. All dimensions,
information and specifications in these
operating instructions are therefore not
guaranteed. As such, no assertion of legal
claims can be enforced on the basis of the
operating instructions.
Replacement parts/
Accessories
Spare parts and accessories
can be obtained at
www.grizzly-service.eu
If you do not have internet access, please
contact the Service Centre (see "Grizzly
Sercice-Center"). Please have the order
number mentioned below ready.
Spare blade ............................. 13700233
Grass catcher ........................... 91095815