shark S 600 Manuel D'utilisation page 13

Table des Matières

Publicité

13
JuGulaire • chin StraP • Kinnriemen • cinturino • cincha
Boucle "Precise Lock" • "Precise Lock" buckle • Verschluss „Precise Lock" • Fibbia "Precise Lock" • Cierre "Precise Lock"
HOLDING SYSTEM
Depending on the various versions and the
country concerned, your S 600 SHARK helmet
is equipped with a chin strap with a "Precise
Lock" rapid buckle with a snap lock or one
with a double D ring.
The "Precise Lock" snap lock system gives
you precise and accurate adjustment becau-
se of the considerable length of its notched
section.
However, it is essential on purchase to adapt
the length of the chin strap to your measure-
D
ments. Adjust the length of the strap using
the adjusting buckle (Figs. A, B, C and D).
Choose your S 600 helmet and attach the
holding system. When the "Precise Lock"
is adjusted to the medium position, the chin
strap must be correctly tensioned under the
jaw to hold the helmet firmly without causing
you any discomfort or pain.
To fasten the chin strap, all you have to do is
to thread the tongue into its place on the buc-
kle until tension is perfect (Fig. E). The tongue
connects and is automatically blocked.
To release the chin strap, you have to pull on
E
the lever (Fig. F) and remove the tongue from
the buckle. Although the notched tongue
enables you to change the adjustment pre-
cisely on each use, it is important to check
frequently that the adjustment of the strap
length is correct. Warning: never ride with
the chin strap loose or insufficiently tighte-
ned. Even though the interior padding gives
you the impression of being held, your helmet
risks coming off in a fall.
Never apply lubricating, acid products, grease
or solvents to the chin strap buckle parts.
F

Publicité

Table des Matières
loading

Table des Matières