Troubleshooting - Sonnenkonig SECCO 200 Manuel De L'utilisateur

7 Troubleshooting

If you experience any of the problems listed below, please check the following points
before calling customer service.
Problem
The unit does not operate.
The dehumidifying
function does not work.
No air is discharged.
Operation is noisy.
Possibile cause
Has the power cord been
disconnected?
Is the tank full indication
lamp blinking? (The tank is
full or in a wrong posi-
tion.)
Is the temperature of the
room above 35°C or below
5°C?.
Is the air filter clogged?
Is the air intake or the air
outlet blocked?
Is the air filter clogged?
Is the unit tilted or
on unstable ground?
Is the air filter clogged?
69
Solution
Plug the power cord into
the outlet.
Empty the water in the
drainage tank and then
reposition the tank.
The protection device is
activated and the unit
cannot be started.
Clean the air filter as
explained under „Cleaning
the Dehumidifier".
Clear the blockage from
the air intake or the air
outlet.
Clean the air filter as
explained under „Cleaning
the Dehumidifier".
Move the unit to a solid,
stable location.
Clean the air filter as
explained under „Cleaning
the Dehumidifier".
GB