Sonnenkonig SECCO 200 Manuel De L'utilisateur page 65

Note
1. DO not remove the float from the water tank. The water full
sensor will no longer be able to detect the water level correctly
without the float and water may leak from the water tank.
2. If the drainage tank is dirty, wash it with cold or lukewarm water. Do not use deter-
gent, scouring pads, chemically treated dust cloths, gasoline, benzene, thinner, or other
solvents, as these can scratch and damage the tank and cause water leakage.
GB
3. When replacing the drainage tank, press the tank firmly into place with both hands.
If the tank is not positioned properly, the "TANK FULL" sensor will be activated, and the
dehumidifier will not operate.
Continuous Water Drainage
The unit features a continuous drainage port . Using a plastic pipe (with an inner diameter
of 9 mm) tthe water in the drainage tank can be continuously drained through the cont-
inuous drainage port on the unit.
This stopper is inserted after removing the tank, so that the direct drain can function properly.
65