Sonnenkonig SECCO 200 Manuel De L'utilisateur page 63

Push Button Functions
Power Push Button
Press the button once to start operation, the default humidity level is 60%. Press
it again to stop operation.
Swing push button
Press the button once to swing the air outlet louver, iIt will stop when you press
the button again.
GB
Timer Push Button
1. Setting a start time
When the appliance is plugged in, press the Timer button first and then press
Up/Down to set the start time.
2. Setting an end time.
3. Press the timer key and the arrow key to reset the timer.
Humidity Push Button
Press to set the desired humidity level in the room, which can be set in the order
of: 60%, 65%, 70%, 75%, 80%, 40%, 45%, 50%, 55%, 60%. After reaching
the desired humidity, both the compressor and the fan go to standby and are
activated at the time when the room humidity exceeds the desired level of hu-
midity.
Fan Speed Push Button
Press to set the desired fan speed. It can be adjusted between high speed and
low speed.
Ion / UV Push Button
Press to start the Ion / UV function. The green / blue LED light will turn on when
the Ion / UV function is operating. Press the button again to cancel the ionic/
UV function.
Up / Down button
Press the Timer button first and then press the Up/Down button to set the time.
Pressing the Up/Down button once, adds/deducts 1 hour.
Press the Humidity button first and then press the Up/Down button to set the
humidity level. Pressing the Up/Down button once, adds / deducts 5%.
63