Angelo Po 1G1FAPG Manuel D'utilisation Et D'installation page 56

REPLACING OVEN BURNER PILOT LIGHT NOZZLE
To carry out this operation, proceed as follows.
1 - Access the pilot light through the opening pro-
vided in the bottom of the appliance.
2 - Unscrew the cap (B).
3 - Remove the nozzle (C) and replace it with the
one suitable for the type of gas in use (see table
at back of manual).
4 - Replace the cap (B).
REPLACING PLATE BURNER AIR BUSHING
To carry out this operation,
proceed as follows.
1-Turn off the gas supply
tap.
2 - Pull off the knob (A).
3 - Undo the screws
(B) and remove
the control panel
(C).
4 - Undo the screws
(D) to remove the sup-
port (E).
5 - Unscrew and remove
the burner nozzle (F).
6 - Replace the bushing (G) with the one suitable
IT
for the type of gas in use as shown in the table.
7 - When replacing the bushing, screw it in until it
is resting against the burner intake hole.
GB
DE
FR
DECOMMISSIONING AND SCRAPPING THE APPLIANCE
When decommissioning the appliance, a series of
ES
procedures must be carried out to ensure that the
appliance and its components are not a hindrance
and are not easily accessible.
To ensure that the appliance cannot constitute haz-
ards for people or the environment, all energy
sources (electricity, etc.) must be disconnected and
rendered unusable, and any liquids present must
be drained (lubricants, fluids, etc.).
Place the appliance in a suitable area which is not
easily accessible, with barriers to prevent anyone
from accessing it.
English
B
C
A
Gas family
II (G 20-25)
III (G 30-31)
8 - Replace the nozzle (F), the support (E) and the
control panel (C) when the operation is com-
plete.
When scrapping, sort all components by chemical
characteristics and dispose of them separately in
accordance with the relevant legal requirements.
Important
Do not dump non-biodegradable products,
lubricating oils, and non-metallic compo-
nents (rubber, PVC, resins, etc.) in the envi-
ronment. Dispose of them in compliance
with the relevant laws.
- 26 -
C
B
IDM-39603610900.tif
G
E
F
D
IDM-39618501900.tif
Air bushing
ø30 - 6 holes § 6,50 mm
ø30 - 9 holes § 6,25 mm