Replacing Parts; Instructions And Warnings For Replacing Parts; Replacing The Plate Burner Nozzle - Angelo Po 1G1FAPG Manuel D'utilisation Et D'installation

INSTRUCTIONS AND WARNINGS FOR REPLACING PARTS

Before carrying out any replacement procedure, ac-
tivate all the safety devices p rovided and decide
whether staff at work and those in the
should be informed. In particular, turn off the gas
supply tap and prevent access to all devices which
might cause unexpected health and safety hazards
if turned on.
If work parts have to be replaced, use original spare
parts only.

REPLACING THE PLATE BURNER NOZZLE

To carry out this operation,
proceed as follows.
1-Turn off the gas supply
tap.
2 - Pull off the kno b
(A).
3 - Undo the screws
(B) and remove
the control panel (C).
4 - Unscrew the nozzle (D)
and replace it with th e
one suitable for the type
of gas in use (see table
IT
at back of manual).
5 - Replace the control panel (C) and the knobs (A)
on completion of the operation.
GB
DE
REPLACING THE TOP BURNER NOZZLE
To carry out th is operation,
FR
proceed as follows.
1 - Turn off the gas supply
ES
tap.
2 - Remove the grid (A).
3 - Extract the burner (B).
4 - Unscrew the nozzle ( C)
and replace it with th e
one suitable for the type
of gas in use (see table
at back of manual).
5 - Replace the burner and
the grid.
English

REPLACING PARTS

vicinity
A
A
- 24 -
The manufacturer declines all responsibly for injury
or damage to components due to the use of non
original parts, or extraordinary work on the appli-
ance which may modify the safe ty requirements
without the manufacturer's authorisation.
When ordering components, follow the instructions
provided in the parts catalogue.
C
B
B
D
IDM-39618501600.tif
IDM-39618501700.tif
9
8
C