Angelo Po 1G1FAPG Manuel D'utilisation Et D'installation page 38

– Carry out cleaning procedures when reasonably
necessary, and always after each use of the ap-
pliance.
– When cleaning and sanitising the appliance with
detergents, always wear personal protection
equipment (gloves, masks, goggles, etc.) as re-
quired by the relevant health and safety legisla-
tion. .
– At the end of each session of use, make sure that
the burners are off, with the control knobs turned
off and the gas supply lines disconnected.
– In the event o f lengthy periods out of u se, thor-
oughly clean all internal and external parts of the
appliance and the su rrounding area (in accord-
ance with the man ufacturer's instructions) and
disconnect all supply lines.
.
The electrical equipment has been designed and
IT IT constructed in accordance with the relevant regula-
tions. These regulations consider operating condi-
tions in relation to the surrounding environment.
GB GB
The list specifies the conditions required for the cor-
rect operation of the electrical equipment.
DE DE
– The room temperature must not be less than 5°C.
– Relative humidity must be between 50% (meas-
FR FR
ured at 40°C) and 90% (measured at 20°C).
– The place of installation must not be a source of
ES ES
electromagnetic interference and radiation (X-
rays, lasers, etc.).
– The room must not have area s with concentra-
tions of gas or powders which are potentially ex-
plosive and/or represent a fire hazard.
– The products and materials used during produc-
tion and maintenance must not contain contam-
inants or corrosives (acids, chemicals, salts,
etc.) and must not be able to penetrate and/or
come into contact with
nents.
English
SAFETY WARNINGS AND INSTRUCTIONS CONCERNING
ENVIRONMENTAL IMPACT
the electrical compo-
– During routine use of the appliance, the Opera-
tor's constant presence is required.
– When washing the appliance do not point pressu-
rised water jets at internal parts.
– Do not leave flammable objects or materials in-
side or close to the appliance.
Caution - warning
The floor, near the appliance, could be slip-
pery.
Important
The necessary connections (water, electric-
ity and gas) must be set up exclusively by
suitably specialised staff , in accordance
with local requirements.
– During transport and storage, the a mbient tem-
perature must be between -25°C and 55°C.
However, the electrical equipment may b e ex-
posed to a temperature of up to 70°C, provided
the exposure time does not exceed 24 hours.
If it is not possible to comply with one or more of the
conditions listed, essential for corr ect operation of
the electrical equipment, agr eement must be
reached in the contract con cerning the additional
features required to create the most suitable condi-
tions (e.g. special electrical components, air-condi-
tioning equipment, etc.).
- 8 -