Adjustments; Instructions And Warnings For Adjustments - Angelo Po 1G1FAPG Manuel D'utilisation Et D'installation

INSTRUCTIONS AND WARNINGS FOR ADJUSTMENTS

Important
Before making any type of adjustment, acti-
vate all the safety devices provided and de-
cide whether staff at work and those in the
vicinity should be informed.
In particular, turn off the gas supply tap and
prevent access to all devices which might
ADJUSTING GAS CONTROL VALVE MINIMUM SETTING (PLATE)
Important
This adjustment is only required if the type
of gas to be connected is different from that
used for testing after the conversion proce-
dure has been carried out (see page 19). Be-
fore making this adjustment, check that the
gas supply pressure is the same as the rat-
ed pressure for the type of gas in use (see
table at back of manual).
ADJUSTING GAS CONTROL VALVE MINIMUM SETTING (TOP BURNERS)
Important
This adjustment is only required if the type
of gas to be connected is different from that
used for testing after the conversion proce-
dure has been carried out (see page 19). Be-

ADJUSTMENTS

C
A
- 21 -
cause unexpected health and safety hazar-
ds if turned on.
Important
Adjustments must be carried out by author-
ised, qualifi ed staff , in accordance with the
relevant legal requirements.
To carry out this operation, proceed as follows.
1-Turn off the gas supply tap.
2 - Pull off the knob (A).
3 - Undo the screws (B) and remove the contr ol
panel (C).
4 - Remove the injector (D) and re place it
with the one suitable for the type of gas in
use (see table at back of manual).
5 - After making the setting, seal the screw
with paint.
6 - Replace the control panel (C) and the knobs (A)
on completion of the operation.
B
fore making this adjustment, check that the
gas supply pressure is the same as the rat-
ed pressure for the type of gas in use (see
table at back of manual).
D
IDM-39618501200.tif
English
8
IT
GB
DE
FR
ES