Technical Data; Safety Devices; Safety And Information Signs - Angelo Po 1G1FAPG Manuel D'utilisation Et D'installation

See "Connection card" at back of manual.
Although the appliance is complete with all safety
devices, during installation and connection addi-
tional devices must be added if necessary to com-
ply with the relevant legal requirements.
The illustration shows the position of the devices.
A)Gas supply tap: for turning the connection to the
gas supply line on and off.
B)Safety thermocouple: cuts out the gas supply if
the flame goes out.
Caution - warning
Make a daily check that the safety devices are
properly installed and in good working order.
IT IT
The illustration shows the position of the signs pro-
vided.
A)Nameplate with manufacturer and appliance
GB GB
data.
B)General hazard: read the manual carefully be-
DE DE
fore carrying out any procedure.
C)General hazard: when washing the appliance do
FR FR not point pressurised water jets
parts.
D)General hazard: all relevant regulations must be
ES ES
complied with. "Install in comp liance with the
relevant regulations and use in well ventilated
premises only".
E)General hazard: all relevant regulations must be
complied with. "No liability is accepted in case
of failure to comply with the installation and
commissioning instructions".
F) Burn hazard: watch out for hot surfaces.
G)CE marking: this indicates that the equipment is
compliant with all relevant laws applicable to
the product.
English

TECHNICAL DATA

SAFETY DEVICES

SAFETY AND INFORMATION SIGNS

at internal
B
G
A
- 6 -
B
A
IDM-39609400200.tif
F
D
E
C
IDM-39618500300.tif
B