EUROM Force 2500IND Livret D'instructions page 18


Turn the On/Off switch to the OFF / 0 position (see fig. 9).

Check that the specifications of the socket that you wish to use correspond with those on the type
plate of the machine. If this is the case, insert the plug into the socket.
The terrase-cleaner:
The terrace cleaner consists of 3 parts:
1– connector (X = thread end)
2– cleaner head
3– spinner (Y = tube, Z = rotating connector)

Place the connector on top of the cleaner head. The cleaner
head has
2 holes – the threaded end must be pushed into the large hole.

Turn the cleaning head around and push the inside of the
spinner onto the connector. The tube must be inserted in the
appropriate hole in the threaded end. Now screw the rotating
connector firmly into the threaded end.

The connector fits onto the jet lance (see fig. 6). An adapter is
used to connect the ance to the jet pistol (supplied).
OPERATION

Open the water supply completely.

Unlock the safety lock (see fig. 8).

Now squeeze the trigger for several seconds in order to de-aerate the hose.

Switch the machine on by switching the On/Off button to I / ON (see fig. 9). The motor will start
briefly, but will stop again as long as the trigger is not squeezed.

Now squeeze the trigger – the machine will start.

The automatic start/stop system means that the motor only works when the trigger is
squeezed!

The jet produced by the jet lance can be adjusted from narrow to wide by turning the head of the
lance. By pulling the head of the lance forward you switch from high pressure to low pressure.
do this while you are spraying!

The rotating heaD creates a narrow rotating jet.

The terrace cleaner is intended for the cleaning of hard, even, flat surfaces such as terraces, small
streets, steps, (garden) walls, etc. The cap provides protection from water splashing back. Attention:
the powerful jets can damage softer materials such as paint and wood, etc.!
Detergent mixing:
 Fill the detergent tank with a detergent that does not affect unit and the spray area.
 Work under low pressure. To do so, use the jet lance with the two flat plates (narrow/flat yet) and pull
the nozzle one centimeter forward (see Fig. 12). The detergent is now mixed automatically.
 The detergent button allows you to regulate the amount of detergent that is mixed:
 as far as possible in clockwise direction = maximum volume detergent mixed
 as far as possible counterclockwise = no detergent mixed.
Important: Always point the jet down!
Never