Add Engine Oil; Add Fuel - Briggs & Stratton ELITE 2500 MAX PSI Manuel D'utilisation

6. Align hose wrap (A) to the back side of accessory tray.
Locate notch with "unlock" icon (B) on hose wrap.
Position notch at top with hose wrap in vertical
position. Clips in the back of accessory tray should
slide into the grooves on the inside surface of hose
wrap. Slide hose wrap on back of accessory tray and
rotate 1/8 turn until "locked" icon (C) is in vertical
position. Hose wrap is easily removed from the
accessory tray for wrapping and unwrapping of the
high pressure hose. A clip to secure the hose on the
reel makes it easy to wrap the hose while it is detached
from the accessory tray.
B
A

Add Engine Oil

1. Place pressure washer on a flat, level surface.
2. Clean area around oil fill and remove yellow oil fill
cap/dipstick.
3. Using oil funnel (optional), slowly pour contents of
supplied oil into oil fill opening, frequently checking oil
level. DO NOT OVERFILL.
NOTICE Improper treatment of pressure washer could
damage it and shorten its life.
• DO NOT attempt to crank or start the engine before it
has been properly serviced with the recommended oil.
This could result in an engine failure.
4. Replace oil fill cap/dipstick and fully tighten.
8

Add Fuel

Fuel must meet these requirements:
• Clean, fresh, unleaded gasoline.
• A minimum of 87 octane/87 AKI (91 RON). High
altitude use, see High Altitude.
• Gasoline with up to 10% ethanol (gasohol) or up to
15% MTBE (methyl tertiary butyl ether) is acceptable.
NOTICE Avoid pressure washer damage.
Failure to follow Operator's Manual for fuel
recommendations voids warranty.
• DO NOT use unapproved gasoline such as E85.
• DO NOT mix oil in gasoline.
• DO NOT modify engine to run on alternate fuels.
C
To protect the fuel system from gum formation, mix in a fuel
stabilizer when adding fuel. See Storage. All fuel is not the
same. If you experience starting or performance problems
after using fuel, switch to a different fuel provider or change
brands. This engine is certified to operate on gasoline. The
emission control system for this engine is EM (Engine
Modifications).
WARNING Fuel and its vapors are extremely flammable
WHEN ADDING FUEL
• Turn pressure washer engine OFF and let it cool at least 2
minutes before removing fuel cap. Loosen cap slowly to relieve
pressure in tank.
• Fill fuel tank outdoors.
• DO NOT overfill tank. Allow space for fuel expansion.
• If fuel spills, wait until it evaporates before starting engine.
• Keep fuel away from sparks, open flames, pilot lights, heat, and
other ignition sources.
Full
• Check fuel lines, tank, cap and fittings frequently for cracks or
leaks. Replace if necessary.
Add
• DO NOT light a cigarette or smoke.
1. Clean area around fuel fill cap, remove cap.
2. Slowly add regular unleaded fuel (D) to fuel tank (E). Be
careful not to overfill. Allow about 1.5" (4 cm) (F) of
tank space for fuel expansion.
3. Install fuel cap and let any spilled fuel evaporate before
starting engine.
and explosive which could cause burns,
fire or explosion resulting in death,
serious injury and/or property damage.
E
F
BRIGGSandSTRATTON.COM
D