Lubricate O-Rings - Briggs & Stratton ELITE 2500 MAX PSI Manuel D'utilisation

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

High Altitude
At altitudes over 5,000 feet (1524 meters), a minimum
85 octane / 85 AKI (89 RON) gasoline is acceptable. To
remain emissions compliant, high altitude adjustment is
required. Operation without this adjustment will cause
decreased performance, increased fuel consumption, and
increased emissions. See an Authorized Briggs & Stratton
dealer for high altitude adjustment information. Operation of
the engine at altitudes below 2,500 feet (762 meters) with
the high altitude kit is not recommended.
Fresh Start® Fuel Cap
The Fresh Start® fuel cap (A) is designed to hold a
cartridge (B) which contains fuel preserver. Adding fuel
preserver helps keep fuel fresh and carburetors clean for
easier starting all season long. The Fresh Start® fuel cap, if
equipped with a cartridge, automatically drips concentrated
fuel preserver into your fuel tank so you don't have to add it
yourself.
A
NOTICE Fresh Start® fuel preserver cartridge is available as
an optional accessory. It is not included with the pressure
washer. Contact the original equipment manufacturer,
retailer, or dealer to obtain a cartridge designed for the Fresh
Start® fuel cap installed on this engine.
Read and follow all instructions and warnings given in the
Fresh Start® fuel preserver cartridge package.

Lubricate O-Rings

Lubrication of o-rings is extremely important for installation
and operation. The use of a lubricant (petroleum or synthetic
grease) during assembly helps seat o-rings properly and
provides an improved seal. It also helps protect the o-ring
from damage by abrasion, pinching or cutting and extends
the life of the o-ring.
NOTICE ALWAYS apply a small amount of lubricant on
o-rings prior to assembling the garden hose to the pump (C),
high pressure hose (D), spray gun (E), and nozzle
extension (F).
Lubricate all connections shown below, following these
instructions:
1. Inspect and clean connecting surfaces prior to
B
2. Use lubricants sparingly during assembly; a light film is
3. Use a small brush or cotton swab to apply grease
E
F
D
C
lubrication and assembly.
all that is required.
directly to o-rings where they are not accessible (QC
fitting, M22 fitting).
9

Publicité

Chapitres

Table des Matières
loading

Table des Matières