Nozzle Maintenance; Pump Oil Maintenance; Engine Maintenance - Briggs & Stratton 020223 Manuel D'utilisation

Masquer les pouces Voir aussi pour 020223:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Nozzle Maintenance

A pulsing sensation felt while squeezing the spray gun
trigger may be caused by excessive pump pressure.The
principal cause of excessive pump pressure is a orifice
clogged or restricted with foreign materials, such as dirt,
etc.To correct the problem, immediately clean the orifice
using the tools included with your pressure washer and
follow these instructions:
1.
Shut off engine and turn off water supply.
2.
Detach nozzle extension from spray gun.Twist nozzle
clockwise to stream position. Using 2mm (5/64) allen
wrench, remove orifice from end of nozzle extension
(Figure 16).
Figure 16 — Removing and Cleaning Orifice
Orifice
3.
Use wire (or small paper clip) to free any foreign
material clogging or restricting orifice (Figure 16).
4.
Using garden hose, remove additional debris by back
flushing water through nozzle extension (Figure 17).
Back flush between 30 to 60 seconds.Turn adjustable
nozzle extension to stream spray and move nozzle
from low to high while flushing.
Figure 17 — Backflushing the Nozzle
5.
Reinstall orifice into nozzle extension. DO NOT
overtighten orifice with allen wrench.
6.
Reconnect nozzle extension to spray gun.
7.
Reconnect water supply, turn on water, and start engine.
8.
Test pressure washer by operating with nozzle in high
and low positions.
MAINTENANCE
O–Ring Maintenance
Through the normal operation of your pressure washer,
o–rings are used to keep the connections of the hoses and
spray gun tight and leak–free.These o-rings may become
worn or damaged.
An O–Ring Maintenance Kit is provided with your pressure
washer which includes replacement o-rings, rubber washer
and water inlet filter. Refer to the instruction sheet
provided in the kit to service your unit's o-rings. Note that
you will not use all of the parts in the kit.
To remove a worn or damaged o–ring; use a small flathead
screwdriver to get underneath the o-ring and pry it off.
The high pressure stream of water that this
equipment produces can pierce skin and its
underlying tissues, leading to serious injury and
possible amputation.
• NEVER repair leaking connections with sealant of any kind.
Replace o-ring or seal.

Pump Oil Maintenance

This model does not require any pump maintenance.The
pump is pre-lubricated and sealed, requiring no additional
lubrication for the life of the pump.

ENGINE MAINTENANCE

See the engine operator's manual for instructions on how
to properly maintain the engine.
Avoid prolonged or repeated skin contact with used
motor oil.
• Used motor oil has been shown to cause skin cancer in
certain laboratory animals.
• Thoroughly wash exposed areas with soap and water.
KEEP OUT OF REACH OF CHILDREN. DON'T
POLLUTE. CONSERVE RESOURCES. RETURN
USED OIL TO COLLECTION CENTERS.
15
WARNING
CAUTION

Publicité

Table des Matières
loading

Table des Matières