clage K 5 Mode D'emploi page 21

Mounting
(continued)
200
4. Introduce the swivelling spout (3) with gasket and snap ring fully into the threaded connector so that
the union nut can be tightened down completely.
5. Position the appliance on the water connection (5), making sure that the gasket is correctly seated and
screw on the ¾" union nut (4) by hand.
6. Insert the wall mounting screws (6).
7. If there is a recess due to the tiles on the wall, this difference in height can be compensated by means
of the two spacer sleeves enclosed with the accessories.
8. Lay a spirit level on the appliance and level it in both directions.
9. Use a size 27 fork wrench to correct the water connection so that the appliance is mounted straight
and flat on the wall.
10. Tighten down the wall mounting screws.
11. Tighten the ¾" union nut (4), holding the water connection (5) steady at the same time.
12. Refit the cover.
13. Turn on the water tap.
14. Use the "blue" knob (9) to rinse the appliance with cold water.
198
120
21
293
266
150
2
CLAGE
270
165