Familiarising Yourself With Your Appliance; Basic Operation - CONSTRUCTA CD939850 Manuel D'utilisation Et Notice D'installation

en Familiarising yourself with your appliance
5 Familiarising yourself with your appliance
5.1 Control panel
You can use the control panel to configure all functions of your appliance and to obtain information about the operat-
ing status.
Switching the appliance on or off
Switching the fan run-on on or off
Switching the intermittent ventilation on or off
Decreasing the fan setting
6 Basic operation
6.1 Switching on the appliance
Press ​ ⁠ .
▶
a The appliance starts at fan setting 2.
6.2 Switching off the appliance
Press ​ ⁠ .
▶
6.3 Selecting a fan setting
Press ​ ⁠ or ​ ⁠ .
▶
6.4 Switching on intensive mode
If particularly strong odours or vapours develop, you
can use intensive mode.
To switch on intensive mode 2, press ​ ⁠ .
1.
​ ⁠ ​ ⁠ appears on the display.
a
To switch on intensive mode 1, press ​ ⁠ again.
2.
a ​ ⁠ ​ ⁠ appears on the display.
a After approx. 6 minutes, the appliance automatically
switches to fan setting 3.
6.5 Switching off intensive mode
Press ​ ⁠ .
▶
6.6 Switching on the fan run-on
During the fan run-on, the appliance continues to run
for a short time and then switches off automatically.
Press ​ ⁠
▶
a The fan run-on starts at fan setting 1.
a The appliance switches off automatically after ap-
prox. 10 minutes.
20
Increasing the fan setting
Switching intensive modes on or off
Resetting the filter saturation indicator
Switching the lighting on or off
Setting the brightness
6.7 Switching off the fan run-on
Press ​ ⁠
▶
6.8 Switching on intermittent ventilation
With intermittent ventilation, the appliance switches the
ventilation on and off at regular intervals.
Press ​ ⁠ .
▶
a The appliance runs for 5 minutes per hour at fan
setting 1.
6.9 Resetting the saturation indicator
After cleaning the grease filter or after changing the
odour filter, the saturation indicator can be reset.
Note: The saturation indicator does not apply for non-
regenerative odour filters that are inserted downstream
of the grease filters. These odour filters must be re-
placed twice a year.
Requirements
¡ After the appliance has been switched off,
pears on the display for the grease filter.
¡ After the appliance has been switched off,
pears on the display for the odour filter.
Press ​ ⁠ .
▶
a The saturation indicator is reset.
6.10 Setting the saturation indicator
The saturation indicator must be adjusted depending
on the filter used.
Requirement: The appliance is switched off.
To set circulating-air mode (non-regenerative filter),
1.
press and hold ​ ⁠ and
on the display.
​ ⁠ ap-
​ ⁠ ap-
​ ⁠ until indicator 2 appears