End Of The Product's Working Life; Technical Specifications - Baxi MS UNIVERSALE+ Instructions D'installation

8.3 SECOND LOW TEMPERATURE ZONE (TA2)
Use an ambient thermostat supplied as an accessory.
Regulate the management of the second low temperature zone by means of the potentiometers P1 or P2 of the electronic
board of the MS UNIVERSALE+. The ambient temperature must be regulated with the ambient thermostat.
8.3.1 With MS UNIVERSALE+ external probe
The climate curve must be chosen by means of the potentiometer P1 on the electronic board (Figure 4). See the graph §
5.7 for the choice of the curve to set.
Regulate the potentiometer P2 at the maximum temperature value contemplated for the type of system (set a value lower
than 40°C).
8.3.2 Without MS UNIVERSALE+ external probe
Regulate the potentiometer P2 at the maximum temperature value contemplated for the type of system (set a value lower
than 40 °C).

9. END OF THE PRODUCT'S WORKING LIFE

This product has been made of materials that do not pollute the environment. At the end of its working life it must not be
treated as domestic refuse, but consigned to the nearest centre for collecting and recycling equipment.
It must be disposed of in accordance with the environmental regulations in force for waste disposal.
Power supply voltage
Rated frequency
Absorbed power 2 pumps model
Absorbed power 3 pumps model
Housing box dimensions
Weight 2 pumps model
Weight 3 pumps model
Weight housing box
As Baxi S.p.A. constantly strives to improve its products, it reserves the right to modify the information contained in this document at any
time and without prior notice. This document is issued purely for the sake information and should not be considered as a contract with third
parties
INSTALLATION INSTRUCTIONS

10. TECHNICAL SPECIFICATIONS

29
AC 230 V
50 – 60 Hz
95 W
140 W
700x450x210 (mm)
14 Kg
17 Kg
10 Kg
7225991.02 - en