Autotest Procedure By Using Aurora Communicator - Aurora PVI-10.0-I-OUTD-400 Manuel D'utilisation

Use and installation manual
(PVI-10.0/12.0-I-OUTD(-S)-400 Rev:1.3)
5.6

Autotest procedure by using AURORA Communicator

The Autotest procedure can be carried out by using the AURORA Communicator
software, included in the CD provided.
To carry out autotests, follow the procedure below:
Install the AURORA Communicator software on your PC.
-
Connect the inverter to the PC by using the RS485/UBS converter
-
Start-up the AURORA Communicator software
-
The following will be shown on the start-up screen:
•
Click on Configuration > Configure Inverter
77 97
Page of