Publicité
Les langues disponibles
Les langues disponibles
FRONT AND REAR SUB-TABLE KIT
KIT PN 2879215
3.4. Install the rubber bushing (#1) over the bushing
spacer tube (#2).
3
Figure 10
3.5. Slide the anti-rotation assembly into the hole
on the bottom of the sub-table (#4).
3.6. Install the rubber bushing (#1) over the
bushing spacer tube (#2).
3.7. Install the
3/4" I.D. X 2" O.D. X 1/8"
(#16) over the bushing spacer tube (#2).
3.8. Install the rubber bushing (#1) over the
bushing spacer tube (#2).
3.9. Install the
50 mm O.D. X 17 mm I.D. X 3 mm
washer (#17) onto the threaded part of the
anti-rotation tube (#3).
3.10. Screw the
5/8" nc
threaded part of the anti-rotation tube (#3).
Finger tighten only at this time.
4
Figure 11
2510338
A-2510338
1
2
17
12
flat washer
flat
nylock nut (#14) onto the
14
17
1
16
1
3
4. Repeat steps 2 and 3 for the opposite side.
5. Use the
lug nuts (#7) to install the Track Kits
M12-1.5
on the wheel axles.
7
Figure 12
NOTE: Refer to the Track Kit manual to complete the
installation and adjustment.
- 8-
Publicité
