Publicité
Les langues disponibles
Les langues disponibles
FRONT AND REAR SUB-TABLE KIT
KIT PN 2879215
4.4. Tighten the nuts (#18) installed in step 4.2. and
make sure they fit snugly.
Torque to 20 ft-lbs.
Tighten in a manner not to permanently
deform the sub-table.
Front Anti-rotation Installation
(see Figure 1 - Table 1 (page 3) for the front anti-rotation
exploded view and the parts list)
5. Install the front anti-rotation assembly on the sub-
table following these steps:
5.1. Assemble the ball joint (#22) and the
nut (#17) to the front anti-rotation assembly.
5.2. Install the large ball joint spacer (#1) with the
narrow part facing down onto the
carriage bolt (#15) installed in step 3.
NOTE: Pay special attention to the orientation
given to spacers (#1 and #2) during installation.
5.3. Install the ball joint of the anti-rotation
assembly (#22) onto the bolt (#15), below the
large ball joint spacer (#1).
5.4. Install the short ball joint spacer (#2) with the
narrow part facing up, below the anti-rotation
assembly.
NOTE: Pay special attention to the orientation
given to spacers (#1 and #2) during installation.
5.5. Tighten the assembly with a
(#19).
Torque to 65 ft-lbs.
Figure 6
2510338
A-2510338
thin
1/2" nf
1/2" nc X 3"
nylock nut
1/2" nc
15
1
22
2
17
19
WARNI NG
If the bolts are not sufficiently tightened, there is a
risk of them becoming loose, of parts detaching and
risk of loss of control over the vehicle, as well as risk
of personal injury.
5.6. Rotate the anti-rotation assembly towards the
center of the UTV to prevent it from inter-
fering with the installation of the Track Kit.
6. Repeat steps 2 to 5 for the opposite side.
7. Use the
lug nuts (#12) to install the Track
M12-1.5
Kits on the wheel axles.
12
Figure 7
NOTE: Refer to the Track Kit manual to complete the
installation and adjustment.
- 6-
Publicité
