Peak Detection Charger; Supplied And Required Equipment; Xxx-Sct Electronics System Overview - Losi LOS 1/10 ReadyLift XXX-SCT RTR Manuel D'utilisation

PEAk DETECTION ChARGER

Peak detection chargers monitor the battery during charging and
automatically shut off upon full charge. You can either purchase a peak
detection charger that plugs into a household AC wall socket or one
that requires you to also purchase a 12V power supply.
If using a charger other than a peak detection charger, make sure your
battery is fully discharged prior to charging. Many of these have a
15–20 minute timer that allows you to set a charge time. If the battery
is not fully discharged, you can potentially over-charge your battery
pack. Do not charge any battery unattended, and monitor for heat
build up. If the battery pack is more than warm to the touch, immedi-
ately discontinue charging. Read all safety precautions supplied by the
charger and battery manufacturer.
LOSI MOTOR
BIND PLUG
LOSB9602

XXX-SCT ELECTRONICS SySTEM OvERvIEw

LOSI MSC12L
SETUP BUTTON
ON/OFF SWITCH

SUPPLIED AND REQUIRED EQUIPMENT

Supplied tools
• 2-Way wrench
• 4 Hex Wrench "L" shaped
• Flat Turnbuckle Wrench
Recommended Accessories
• Hobby grade knife
• Side cutting pliers
• Soldering iron
• CA glue (LOSA7880 or LOSA7881)
Required Equipment
• A 6- to 7-cell NiMH battery pack. Or with proper knowledge, LiPo
battery packs.
• NiMH battery charger with automatic peak detection
recommended (LiPo charger if using LiPo battery).
EC3 BATTERY PLUG
™
STEERING SERVO
SPEKTRUM SPMSR300
4
• Transmitter/Receiver BIND Plug
• .050, 1/16, 5/64, and 3/32
• 4 AA Alkaline Batteries
• Needle nose pliers
• Safety goggles
• Double-sided tape (LOSA4004)