Preparing For The Installation Of The Tv - Sony SU-WL450 Informations D'installation

Preparing for the Installation
of the TV
Note
 Be sure to store the removed screws and unused parts
in a safe place, keeping them away from children.
1
Attach the Table-Top Stand to
make the TV standing.
• Refer to your TV's Setup Guide.
2
Remove the terminal covers.
3
Remove the screws from the rear
of the TV.
4
Attach the Attachment parts for
Wall-Mount Bracket. Check the
Attachment parts by referring
to "Supplied with SU-WL450" in
"Checking the Parts" on page
6.
Note
 Firmly secure the Attachment parts using screws.
 When using an electric screwdriver, set the torque
setting to approximately 1.5 N·m {15 kgf·cm}.
If standard mounting (2-a) is selected:
 Belt
If slim mounting (2-b) is selected:
Note
 You cannot use some of the terminals on the rear
of the TV when using this mounting style.
 Belt
5
Connect the necessary cable(s)
to the TV.
Make sure to connect the cables before
installing the TV on the wall. You will be
unable to connect the cables when the TV is
installed.
Note
 Subcontract the cable routing in the wall to a
licensed contractor.
 Bundle the connecting cables to prevent stepping
on them before wall mounting.
− 10 (GB) −
 Pulley
 Screw
(+PSW 6 × 20)
 Screw
(+PSW 6 × 50)
 Spacer
(60 mm)
 Pulley
 Screw
(+PSW 6 × 20)
 Screw
(+PSW 6 × 20)
 Spacer
(20 mm)