Led Indications - Stecom TOPLINE Mode D'emploi

14. LED INDICATIONS

In the following three tables, there is an overview of the LED displays on the control unit and
the extensions. There are two operating modes namely "normal operation" and "reading the
alarm memory", and in each case the LED's have different reasons for illuminating or extin-
guishing - please observe the corresponding table.
Control unit, normal operation (system is armed or disarmed)
LED's
OFF
ON
FLASHES SLOWLY
FLASHES VERY
SLOWLY
FLASHES QUICKLY
FLASHES SLOWLY
(all other LED's off)
Note:
*1 - If all yellow LED's are flashing, a general alarm signal has been received. (SS = switching
socket, MD= motion detector)
*2 - The display alternates with the actual state display.
Central Control unit, alarm memory display
LED's
Green LED for siren,
SS and alarm switch.
Yellow LED for PIR
Seite 35
Green LED for siren,
switching socket and
alarm switch, yellow
LED for detector
Comp. not available /
not receiving
Normal operation /
receiving clearly
Comp. reports (MD)
Comp. active (siren /
switching socket) /
alarm switch) *1
-
Comp. Present / bad
reception *2
-
OFF
No alarm
Red LED "active"
System disarmed
System armed
Arming in processdelay -
alarm triggered
in process
An alarm had been
triggered, System is
rearmed
Arming of alarm in
process (after acoustic
warning ) or alarm is
active
-
ON
Alarm triggered due
to tampering
LED "active" and
"automatic light"
Together / alternately
-
-
-
-
Initial operation in
process.activated
Transmission monitor
FLASHES SLOWLY
Burglary Alarm
English