Time Format Menu; Configuring The User-Defined; Feedback Menu - Flyer Upstreet6 Notice Originale

The check mark indicates which unit is currently
applied . Press the joystick to apply the new set-
tings after confirmation (see 5.3).
5.5.7 Time format menu
In the time format menu, you can switch between
the 24-hour and 12-hour clock.
The check mark indicates which clock format is
currently applied . Press the joystick to apply the
new settings after confirmation (see 5.3).
5.5.8 Configuring the user-defined assistance
In the assistance menu, the four assistance le-
vels (ECO, STD, AUTO, HIGH) can be individu-
ally configured. The torque boost can also be set.
For each of the assistance levels, the maximum
motor performance can be configured in six steps.
The maximum motor performance is lowest at the
very left (only one black bar) and highest at the
very right .
With the exception of AUTO mode, there cannot
be any overlaps . ECO mode is always weaker
than STD mode .
Torque gain (see image below) can be used to
configure how hard the rider has to push on the
pedals to achieve a certain level of motor perfor-
mance .
If 'weak' is selected here (only one black bar),
the rider has to push the pedals relatively hard
to attain the maximum motor performance in the
respective assistance level .
If 'strong' is selected, the maximum motor perfor-
mance for the respective assistance level is at-
tained with relatively little pedalling force .
5.5.9 Feedback menu
In the feedback menu, you can configure the vi-
bration feedback of the remote . The following set-
tings can be selected:
Selection Description
Off
No vibration feedback
On Every button press and every
active error message gener-
ates vibration feedback
Errors only Vibration feedback is only
generated by active error
messages
9
EN