Things To Watch For; Lighting The Burners - ETNA T109V Notice D'utilisation

Things to watch for

Clean immediately
Any spillage should be removed
n
immediately, particularly red cabbage,
apple sauce and rhubarb. These can leave
permanent spots on the enamel or on
stainless steel.
Burning in of the enamel
The burners cause the saucepan supports
n
to get extremely hot. Over time the enamel
on the support points can burn in. This
cannot be prevented and is not covered by
the guarantee.
Burner caps
Check regularly to ensure that the caps of
n
the burners are properly in position on the
burner depressions; improper positioning
can make it difficult to light the burners,
give rise to an irregular gas flame, or
damage the burner caps.
Burner cap
Burner ring
Spark plug
Thermocouple
Burner casing
Injector

Lighting the burners

Electrical spark switch
Press the knob of burner in and turn it to the
n
left to the symbol. The spark switch will
generate sparks and the burner will light
automatically. If the burner fails to light
after repeated attempts, check to ensure
that the burner cap is properly positioned.
Thermocouple protection
This appliance is fitted with a thermocouple.
This is a thermoelectric protection system. It
ensures that the gas tap is closed if the flame
goes out.
Press the desired control knob and turn it
n
to the left to the maximum setting. Press
the ignition until the burner ignites. Hold the
control knob pressed in for 5 seconds.