Table des Matières
Publicité
GENERAL
Introduction to installation
•
Carefully read the guide before installing the appliances.
•
The installation requires safety equipment and a range of tool:
•
The appliance is equipped with all the hardware needed for its installation and is suitable for
most furniture.
•
Check that the minimum surface and volume required in the base of the cabinet is adequate
for installation.
600
•
Minimum height of the cabinet base is very important (min. 100 mm) in order to allow the
passage of the air ducts below the base of the furniture.
•
Prepare the holes in the work top and cabinet bottom and fix the induction hob as shown
according to the dimensions indicated (see 'Built in dimensions').
•
Before inserting the appliance into the hole in the kitchen worktop, the supplied foam gasket
must be attached to the bottom side of the glass.
CAUTION! Do not install the appliance without the foam gasket!
•
Veneer or other finish of the piece of kitchen furniture into which the hob is to be built in
should be treated with heat resistant glue (100° C); otherwise, the worktop finish may be
discoloured or deformed. Ideally the appliance should be installed with plenty of space on
either side (A). There may be a wall at the rear and a tall unit or wall at one side. On the
other side, however, no unit or divider should stand higher than the appliance (B and C).
•
To prevent fire it is not possible to place higher cabinets or walls on both sides (D).
•
Use of wood decoration plates or boards on the worktops behind the appliance is not
permitted.
EN 10
900
100 mm
Publicité
Table des Matières
