Stopping The Engine; Care & Maintenance - Power Fist 8893521 Manuel De L'utilisateur

V 4.0
The engine may make a metallic rapping noise (spark knock, ping) while
running under a heavy load. This is normal. Replace the fuel with premium
quality gasoline if the metallic rapping noise continues under normal load.
Contact a qualified mechanic if the pinging continues as this may indicate
existing engine damage.

STOPPING THE ENGINE

CAUTION! Do not choke carburetor to stop engine. In an emergency turn the
engine switch to the OFF position to stop the engine.
Stop the engine by following this procedure:
1. Move the throttle lever (E) to the MIN. position.
2. Turn the engine switch (F) to the OFF position.
3. Turn the fuel valve (I) to the OFF position.
CARE & MAINTENANCE
WARNING! Always ensure that the engine is off before you begin any
maintenance or repairs. An active engine part can cause a severe injury,
amputation or death if a mishap occurs.
The following section includes a maintenance schedule, routine inspection
procedures and simple maintenance procedures using basic hand tools. Service
tasks that are more difficult or require special tools are best handled by a
technician or other qualified mechanic.
1. Maintain the engine with care. A well-maintained engine is more efficient
and less likely to have problems.
2. Follow instructions for servicing.
3. Inspect the engine components periodically. Check fuel lines, tank, cap and
fittings frequently for cracks or leaks. Have damaged or worn components
repaired or replaced by an authorized technician.
4. Replacement parts must match the original. Use manufacturer
recommended parts when possible.
5. Disconnect the spark plug lead and keep it away from the spark plug
during maintenance and repairs.
Visit www.princessauto.com for more information
Engine for the 15 Ton Kinetic Log Splitter 8893521
7