Preparation For Use; Unpacking And Set Up; Power Source - SOUNDMASTER NR975 Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 18

PREPARATION FOR USE

UNPACKING AND SET UP

Carefully remove the unit from the display carton and remove all packing
materials from the unit.
Unwind the AC power cord and extend it to its full length.
Unwind the UKW Antenna wire and extend it to its full length.
Place the unit on a stable, level surface, convenient to an AC outlet, out of
direct sunlight, and away from sources of excess heat, dust, moisture,
humidity or strong magnetic fields.
Open the CD door. Lift the CD diskette
cover, remove the tr ansit card which was
used to secure the laser duri ng shipment
and dispose of this card.
Connect the plug to your AC outlet.

POWER SOURCE

This system is designed to operate on normal 230V 50Hz AC only. Attempting to
operate this system from any other power source may cause damage to the
system and such damage is not covered by your warranty.
NOTE:
You will note that this system is equipped with a polarized AC power plug. If this
plug does not fit into your existing AC outlet, you probably have an outdated
non-polarized AC outlet. You should have your outlet
licensed electrician.
changed by a qualified

Publicité

Table des Matières
loading

Table des Matières