Güde GSH 6501 B Traduction Du Mode D'emploi D'origine page 19

Placing in storage
If you do not intend to use the leaf vacuum and shredder for a lengthy period of time, you should carry out the following work.
Thoroughly clean and touch up paintwork damage. Grease the lubrication points and allow the leaf vacuum and shredder to run for 1 - 2
minutes. Spray the sweeping brush and chassis with anti-corrosive oil. Thoroughly clean and dry the leaf catcher bag.
Position and store the leaf vacuum and shredder
Do not transport, position or store the leaf vacuum and shredder tilted forwards, backwards or to the side.
Do not keep the leaf vacuum and shredder in damp rooms, in rooms in which artificial fertilisers are stored, in stables or in rooms next to
them. Tilting the machine may allow engine oil to get into the combustion chamber which may cause starting difficulties and oil coking,
giving rise to a danger of serious corrosion.
Troubleshooting
If your pavement vacuum suffers faults which require major intervention, always have it repaired by a professional workshop. Inexpert
intervention may cause damage.
If faults cannot be rectified using the remedies described below, consult a professional workshop.
Fault
Engine does not start
Engine stops after starting
Engine cuts out
Engine cuts out at high speed
Engine has too little power
Engine becomes too hot
Cause
Engine switch not in position "I" (On)
Fuel cock closed
Choke lever open
Spark plug connector not connected
Spark plug dirty or defective
Spark plug electrode gap incorrect
Fuel tank empty
Fuel old
Air filter dirty
Spark plug electrode gap too large
Spark plug dirty or defective
Spark plug connector or cable loose
Fuel screen dirty
Ventilation in fuel tank cover blocked
Air filter dirty
Fuel old
Spark plug electrode gap too small
Air filter dirty
Sweeping brush brakes by foreign bodies
Cooling air system restricted
Too little engine oil
Air filter dirty
Remedy
Move engine switch to position "I"
Open the fuel cock
Close the choke lever
Connect the spark plug connector
Clean or replace the spark plug
Set the electrode gap to 0.7
Refuel
Replace the old fuel with new
Clean the air filter
Set the electrode gap to 0.7
Clean or replace the spark plug
Secure the spark plug connector on the spark plug,
secure the spark plug cable
Clean the fuel screen
Replace the fuel tank cover
Clean the air filter
Replace the old fuel with new
Set the electrode gap to 0.7
Clean the air filter
Remove foreign bodies from the sweeping brush
Clean the air grille and cooling ribs
Top up the engine oil
Clean the air filter
–
0.8 mm
–
0.8 mm
–
0.8 mm