Installing The Sim Card; Power Supply - Spypoint LIVE Manuel De L'utilisateur

6

INSTALLING THE SIM CARD

Insert your SIM card into the compartment provided for this purpose
SPYPOINT LIVE
in your
located under the batteries. You need to use a Phillips screwdriver
to open and close the compartment.
1. Unscrew the cover screw using a Phillips screwdriver.
2. Slide the metal bracket in the OPEN position.
3. Lift up the metal bracket.
4. Insert the SIM card as indicated.
5. Lower the metal bracket and slide it to the LOCK position .
6. Close the compartment cover.
camera. The SIM card compartment is

POWER SUPPLY

The battery level is shown in the upper left corner of the screen
when the camera is in "Test" mode. When a single line remains, the
camera will continue to take pictures but we strongly recommend
changing the batteries before they are empty (see figure below).
AA BATTERIES
This camera requires the use of 8 AA batteries (1.5V). The use of
alkaline or lithium batteries is strongly recommended. Also note
that the voltage of rechargeable AA batteries (1.2V) is insufficient
to power this camera. During the installation of AA batteries, place
the switch inside the battery case to "ALK" (i.e. alkaline). Insert
the batteries in the camera as indicated. Exact polarity must be
followed. We also recommend the use of new batteries to ensure
maximum performance of your camera.
LITHIUM BATTERY PACK
The camera can be powered by a rechargeable lithium battery pack
LIT-09 (sold separately, see "Options"). This type of battery is less
affected by cold temperatures and lasts up to 3 times longer than
alkaline batteries. During the installation of lithium batteries, place
the switch inside the battery case to "RECH" (i.e. rechargeable).
Insert the batteries in the camera as indicated (see figure below).
7
ALK
RECH