Settings Menu - Spypoint LIVE Manuel De L'utilisateur

12

SETTINGS MENU

Allows the user to set the advanced settings of the camera. To
configure the system in another language, press the "DOWN"
button until the option "Language" is highlighted. Press "OK" and
modify the selection with "UP" or "DOWN" button. Confirm the
choice by pressing "OK". The system will change all the menus in
the selected language.
When selected, some options affect the behaviour of other
options from the list of the settings menu. In this case, the
selected option is displayed in yellow and options affected are
shown in gray.
Date: Set the date as Year/Month/Day
Time:
Set the time as Hour/Minute/Second
Note: The seconds are not printed on the pictures
when "Stamp" option is activated.
Time format: Allows the user to choose between a 12 or
(12h/24h)
24 hours period time displays on the photos.
(eg. 6:00 pm or 18:00)
Delay: Sets the time interval to wait between each
(1min/3min/5min/
detection before the camera records the next
10min/15min/
photo or video.
30min)
Video length: Sets the recording time of video in "VIDEO"
(10s/30s/60s/90s)
mode.
Multi-shot: Allows the camera to take several consecutive
(1/2/3/4/5/6
shots at each detection with a 10 second delay
consecutive shots)
between each photo.
Time Lapse: Allows the camera to take pictures at regular
(Off/10min/30min/
preset intervals. This option may be useful to get
1h/2h)
pictures of animals outside the detection range of
the camera.
When the option "Time Lapse" is enabled:
• The "Delay" option is disabled.
• The "Multi-shot" option is disabled.
• The picture size is reduced to 800x600 in local
recording on the memory card.
Note: The "Time Lapse" recording option only
applies in "PHOTO" mode, not in "VIDEO"
mode.
Time start/
Allows the user to set the period of operation of
Time stop:
the camera. The start and stop time are the hours
during which the camera is in action and can
record pictures or videos.
Example: if the user selects a start time "7:00
am" and a stop time "11:00 am", the camera will
only detect for that period of time and will stay
inactive for the remaining hours. Press "OK"
and use "UP" or "DOWN" to adjust the hour.
Press "OK" again to set the minutes. When the
time is properly set, press "OK" again to go back
to other settings. For an activation of 24 hours,
the same start and stop time must be entered
(example: 00:00 as start time and 00:00 as stop
time. These hours are the default configuration of
your camera)
Note: The hours can be recorded over a 12 or 24
hours period. Refer to the "Time format" option
(00:00 means midnight)
Sensitivity: Sets the detection sensitivity of the camera.
(Low/Medium/
High)
Note: The system detects only heat sources in
motion. So it is important during installation to
avoid as much as possible, objects obstructing
the camera . This prevents the camera from being
triggered because of the sun reflecting on these
objects. (e.g. a tree branch)
13