Spypoint LIVE Manuel De L'utilisateur page 9

16
Mode: Sets the operating mode of the camera.
(Standalone/
Cellular/Security)
When "Standalone" mode is activated:
• The camera operates normally by recording
photos or videos locally on the memory card.
• The
"Synchronize",
"Transmit format" are disabled since no
cellular communication is performed in this
mode.
• The presets of the "Time Lapse" option are
reduced to 15s/30s/1min/5min/10min/30min/
1h/2h. (See the option "Time Lapse")
When "Cellular" mode is activated:
(A subscription to
visit www.myspypoint.com for details)
• The
transmission mode and communicates with
mySPYPOINT
presets of the options "Synchronize" and
"Synchronize at".
• Videos cannot be sent to the
user's account.
• Photos are also stored locally on the memory
card.
Note: In Cellular mode, it is recommended
to use an external 12 volt input (KIT-12V/AD-
12V, sold separately) in order to get best results
and longer battery life (see "Power Supply" for
details).
options "Theft alert", "Carrier",
"Synchronize at"
mySPYPOINT
is required,
camera operates in cellular
server following
mySPYPOINT
and
the
Carrier:
Synchronize:
(1/2/6/12 times
a day)
When "Security" mode is activated, the
operation is the same as in "Cellular" mode,
except:
• Captured images are sent immediately to the
mySPYPOINT
user's account.
• The camera still communicates
mySPYPOINT
server
presets of the options "Synchronize" and
"Synchronize at".
• The "Multi-shot" speed is improved with a 5
seconds delay between each take.
• If the option "Multi-shot" is enabled, the
transmission is performed once the serie of
photos is recorded.
• The option "Security Alert" is available on the
mySPYPOINT
user's account. This option
mySPYPOINT
can be activated via
(see "SMS Configuration" for details).
Note: Security mode is recommended for use
in areas where detections are rare and where the
camera can't be powered of a main electricity
supply. It is a good compromise between security
and battery life.
This setting must correspond with the user's
service provider. Choose the one corresponding
to the SIM card among the list of compatible
providers.
Sets the daily number of synchronisations
between the camera and the server.
This option changes the frequency at which the
mySPYPOINT
camera communicates with the
server in order to update its status or to send
photos on the user's account.
17
with
following the
only