Spypoint LIVE Manuel De L'utilisateur page 5

8
EXTERNAL
The camera can be powered from an external 12 volt DC input such
as a 12 volt battery (KIT-12V, sold separately) or a 12 volt adapter
(AD-12V, sold separately). When using a 12 volt connection, we
recommend removing the AA batteries to prevent surcharges. During
the installation of a 12 volt connection, place the switch inside the
battery case to "ALK" (i.e. alkaline). If combined with a lithium
battery pack, slide the switch to "RECH" (i.e. rechargeable). To find
the accessories available for the 12 volt power supply, see "Options".
SOLAR PANEL
This model offers the possibility of a connection to a solar panel SP-
12V (sold separately, see "Options") to maintain the charge of the
lithium battery pack LIT-09 (sold separately, see "Options"). During
the installation of the rechargeable lithium battery pack, slide the
switch inside the battery case to "RECH" (i.e. rechargeable) to
activate the charging system of the solar panel.
MEMORY STORAGE
Using a memory card (sold separately, see "Options") is required
to operate the camera. When the "Photo" or "Video" mode is
selected, the screen displays "No memory card" if no memory card
is present. The camera is compatible with SD/SDHC memory card,
up to 32 GB capacity. Before inserting or removing a memory card,
the camera must be turned off. Failing to do so may cause loss of
pictures or damage the pictures already recorded on the memory
card. When the SD card is full, the viewing screen indicates
"Memory card full" when the "Photo" or "Video" mode is selected.
The used space on the memory card is displayed as percentage in
the upper right corner of the screen when the camera is in "Test"
mode. The following data shows the approximate quantity of photos
or video length that can be taken by the camera depending on the
memory card capacity.
2.0 GB
Photo
5 MP 1190
Video
640 x 480 3h
4.0 GB 8.0 GB 32 GB
2380 4760 19040
5h 11h 43h
MAIN MENU
Use the "UP" and "DOWN" button to navigate the interface or
to modify a selection, the "OK" button to select and the "BACK"
button to return to the previous menu.
PHOTO
Allows the camera to take pictures in Standalone, Cellular or
Security mode (see "Settings Menu" for details).
Standalone: When "Photo" mode is selected, the test light on
the front of the camera flashes for 60 seconds to allow the user to
leave the area without being photographed. A countdown is also
displayed on the screen during boot time.
Cellular/Security: When "Photo" mode is selected, the camera
mySPYPOINT
connects to the
connection status on the screen. The test light on the front of the
camera flashes for 60 seconds to allow the user to leave the area
without being photographed. A countdown is also displayed on the
screen during boot time.
Note: If communication is not established, the "Photo" mode is
defused and an appropriate error message is displayed on the screen.
(See "Error Message" section for details)
VIDEO
Allows the camera to record movies in Standalone mode only.
(see "Settings Menu" for details).
Standalone:
When "Video" mode is selected, the test light on the
front of the camera flashes for 60 seconds to allow the user to leave
without being filmed. A countdown is also displayed on the screen
during boot time.
Cellular/Security:
If the camera is set to Cellular or Security
mode, a message indicates that the camera will be transferred in
Standalone mode and then boots up normally.
SETTINGS
Sets the advanced options of the camera
(see "Settings Menu" for details).
service and displays the
9