Memory Card - Spypoint IR-6 Manuel De L'utilisateur

24
Lithium battery pack with charger
The camera SPYPOINT IR-6 can be powered by a rechargeable
lithium battery LIT-C-8 (sold separately). This type of battery is
much less affected by cold temperatures and lasts up to 3 times
alkaline batteries. During installation of a lithium battery pack,
place the switch inside the battery case to « Rechargeable ».
The solar panel SP-12V (sold separately) can recharge the
lithium battery at any time.
12 volt Power
The camera SPYPOINT IR-6 can also be powered from an
external 12 volt DC input. When using a 12 volt connection,
we recommend to remove the alkaline batteries to prevent
surcharges. The switch inside the battery case can be placed
to « Rechargeable » or to « Alkaline » without any impact. To
find the accessories available for the 12 volt, refer to the section
« OPTIONS ».

MEMOrY CArD

Using a memory card is required to operate the camera
SPYPOINT IR-6. When the camera is « ON » and no memory
card is used, the LCD panel displays « CArd » meaning to
insert one. The SD slot of the camera can accept memory cards
up to 32 GB capacity. Before inserting or removing the memory
card, the camera must be turned « OFF ». Failing to do so may
cause loss of or damage the pictures already recorded from the
memory card. When the SD card is full, the LCD panel indicates
« FULL ». The following data shows an approximate quantity
of photos which can be recorded by the camera depending on
the memory card capacity.
rESOLUTION
4 MP
5 MP
6 MP
8 MP
12 MP
2.0 GB 4.0 GB
1024 2048
816 1632
640 1280
584 1168
480 960
8.0 GB 32 GB
4096 16384
3264 13056
2560 10240
2336 9344
1920 7680