Test Light; Memory Card - Spypoint TINY-W Manuel De L'utilisateur

44
to insert the battery case inside the camera
Connector
POWER (BLACkBOx RECEIvER)
It is possible to know the battery level of the receiver when
it is turned on. The "TEST LIGHT" stays on for 8 seconds
when the batteries are full. When the "TEST LIGHT" flashes
for 8 seconds, the batteries are low and need to be replaced. If
the "TEST LIGHT" remains off, the batteries are completely
empty or are possibly installed in the wrong direction.
SD card slot
Batteries
compartment
12 volt connection
SPY SPY P P INT INT
TM
TINY-W
Connector
SPY SPY P P INT INT
TM

TEST LIGHT

ON/OFF
(bottom view)
Alkaline batteries
The receiver requires the use of 6 AA batteries (1.5V). The
use of alkaline batteries is strongly recommended. Also
note that the voltage of rechargeable AA batteries (1.2V)
is insufficient to power your receiver. Insert the batteries
as indicated. Exact polarity must be followed. We also
recommend the use of new batteries to ensure maximum
performance of the receiver.
12 volts Power
The receiver can also be powered from an external 12 volts
DC input. When using a 12 volt connection, we recommend
you to remove the alkaline batteries to prevent surcharges.
To find the accessories available for the 12 volts, refer to the
section "OPTIONS".
solar panel
The receiver can be powered with a 12 volt battery combined
with a solar panel SP-12V (sold separately, refer to the
section "OPTIONS") to maintain the charge of the 12 volt
battery (sold separately, refer to the section "OPTIONS").

MEMORY CARD

Using a memory card (sold separately, refer to the section
"OPTIONS") is required to operate both the camera
SPYPOINT TINY-W and the Blackbox receiver. When the
camera is turned on, the screen displays "Insert memory
card" in "Photo" or "Video" mode if no memory card is
used, the camera also beeps. The SD slots of the camera
and the receiver have a 32 GB memory capacity. Before
inserting or removing the memory card, the camera or
45