Direct Tuning - Sony ICF-SW1000T Mode D'emploi

Various tuning methods for optimum reception (continued)

Direct tuning

When the desired broadcast station is known,
enter the frequency with the numeric buttons
for immediate selection.
Tips
• When you have entered
the wrong frequency in
step 4, press DIRECT to
cancel the current entry
and enter the correct
frequency.
• "TRY AGAIN!" flashes
when the frequency
entered is invalid and
beyond the allocated
frequency range for
reception. Check and
make sure that the
frequency is valid and
repeat from step 3
again.
• The minimum digit
entry is 0.05 MHz (50
kHz) for the FM band,
and 1 kHz for the AM
band.
Note
Complete each button
operation in steps 3 to 5
within 10 seconds. If
the previously tuned
frequency appears in
the display, repeat from
step 3 again.
16 EN
Radio
RADIO POWER ON/OFF
FM/AM
1
Turn on the radio.
2
Select either FM or AM.
Select AM to listen to SW, MW or LW.
3
Press DIRECT.
The frequency in the display disappears.
4
Enter the frequency of the desired broadcast
station by pressing the numeric buttons.
FM band: A decimal point is not required for entry.
For example, to enter 84.7 MHz, press 8, 4 and 7.
AM band: The lower triple zero digits are omitted for
entry.
For example, to enter 10,000 kHz, press 1 and 0.
5
Press EXE.
When the desired broadcast station is received,
"
TUNE
1 2 3
4 5 6
7 8 9
0
DIRECT EXE
" appears in the display.
Numeric
buttons