TECO 302 Série Traduction Des Instructions Originales page 122

7.11.2 Adjustment of SAFETY height limit switches
• Lower the lift (lift fully lowered)
122
7.11.3 Setting pressure switches lift
WITHOUT MECHANICAL SAFETY DEVICES
• Make sure the lever with the Micro is
in contact with the base plate, then
place the sensor close to a compressed
distance between 1 and 3 mm, tighten
the nuts firmly sensor.
• Disconnect the pressure from the
hydraulic system by pressing the
TRAVEL LIMIT BUTTON 4 and MANUAL
LEVELLING BUTTON 15 at the same
time.
22
23
Operator's m anual