Lift operation can be summarized into four steps:
Place the vehicle at the centre of the platform and adjust the telescopic extensions.
Place pads under the positions indicated by the motor vehicle's manufacturer for lifting..
Set the main switch (1) to 1 position and press UP button to lift the vehicle to the requi-
red level.
8.4 Parking Lift WiTHoUT mECHaNiCaL SaFETY DEViCES
To rest the lift in standing position, release the lifting button when required level is reached.
Stopping of movement occurs automatically.
8.4.1 Parking Lift WiTH mECHaNiCaL SaFETY DEViCES
To rest the lift in standing position, release the lifting button when required level is reached.
Stopping of movement occurs automatically.
STARTING IN SAFE: press start safety yellow to lower the point to what is the mechanical
safety device
8.5 Lowering Lift WiTHoUT mECHaNiCaL SaFETY DEViCES
Push the DOWN button.
The lift will raise to release mechanical safeties, then lower up to a safety height of about
400 mm by the lifted object and it's own weight.
Be sure the safety area is free of people and objects, then press the final travel push button.
Note : it's possible that the lift, without load, does not lift when
there is a bigger quantity of oil in the hydraulic circuit a cause of
some hydraulic needs during the lifting.
In order to make this operation will be necessary to push and to release immediately,
the DOWN button (3) and at the SAFETY down button (14).
8.5.1 Lowering Lift WiTH mECHaNiCaL SaFETY DEViCES
LOWERING: Press the white 'down' button to lower the lift. The lift rises briefly to release
the safety devices before lowering.
If the lift is already at the upper limit switch, it lowers immediately without rising first to
release the safety devices.
The lift lowers as far as the bottom limit switch (proximately 400 mm from the floor). The
buzzer sounds to confirm when the lift has reached the limit switch.
N.B.: Press the yellow safety lock button to lower the lift completely.
Operator's manual
8.2 Vehicle positioning
8.3 Lifting
UK
127