Intended Use; Instructions Before Installation - Dometic MAGICWATCH MWE 820 Instructions De Montage Et De Service

Intended use

4 Intended use
Magic Watch is an ultrasonic parking aid. It monitors space when manoeuvring
• MWE820, 860: behind the vehicle
• MWE890: in front of the vehicle
It provides an audible and visual warning signal for any obstacles it detects.
Magic Watch is designed for installation in cars.
5

Instructions before installation

5.1 Determining the place of installation for the sensors
See fig. 3 to fig. 6
I
NOTE
The sensors must be correctly aligned for the device to work properly.
If these point to the ground, irregularities and bumps on the surface may
be interpreted as obstacles. If they point too far up, obstacles will not be
detected at all.
Note the following during installation:
• The distance from the sensors to the ground should be 50 cm (fig. 3).
• For the sensors to function optimally, the angle of the sensor to the road surface
should be 90° (fig. 3). The angle may not be less than 90°, as the road will oth-
erwise be interpreted by the sensor as an obstacle.
• Observe the positioning of the sensors (fig. 4).
5.2 Painting the sensors
See fig. 2
I
NOTE
The sensors may be painted. The manufacturer recommends having the
sensors painted by a specialist workshop.
6
MWE820, 860, 890
EN