Detection Range; Setting The System; Setting The Sensitivity - Dometic MAGICWATCH MWE 820 Instructions De Montage Et De Service

MWE820, 860, 890
8

Detection range

See fig. d
The detection range of the parking aid is divided into four zones:
• Zone 1 (MWE820, 860 only)
This zone is the first limit range. Small objects or those with poor reflective
characteristics may not be detected.
• Zone 2
Nearly all objects are displayed in this zone.
• Zone 3
Nearly all objects in this zone are displayed, however objects may only appear in
the sensors' blind spot, or not be detected at all due to their consistency or small
size.
• Stop zone (4)
If there are objects in this zone, the parking aid emits a continuous tone warning
you to stop.
Nearly all objects in this zone are displayed, however objects may only appear in
the sensors' blind spot or not be detected at all due to their consistency or small
size.
Displaying fixed objects, such as a trailer hitch, can be suppressed.
9

Setting the system

There is a button (fig. e 1) on the controller for setting the following parameter.
9.1

Setting the sensitivity

➤ Switch on the ignition.
➤ Engage the reverse gear (MWE820, 860 only).
➤ Press the button for not more than two seconds to set the sensitivity in the follow-
ing sequence:
– Low sensitivity: the loudspeaker beeps once
– Medium sensitivity (standard): the loudspeaker beeps twice
– High sensitivity: the loudspeaker beeps three times
Pressing the button repeatedly changes the sensitivity in the above sequence.
EN
Detection range
9