Hydraulic Connections; Condenser Water Inlet And Outlet; Condensate Evacuation; Electrical Connections - SystemAir CX 25 Manuel D'installation Et De Maintenance

HYDRAULIC CONNECTIONS

CONDENSER WATER INLET AND OUTLET

The connections for inlet (supply) and outlet of the water of the condenser must be made with flexible tubes equipped
on their end with a female nut Ø 15 x 21. R mini: 100mm.
ATTENTION:
When connecting the flexible hoses (water inlet and outlet) ensure that they do not touch the compressor and that
they are connected according to their correct marking.

CONDENSATE EVACUATION

Condensed water evacuation is provided by a ø 15 x 20 flexible plastic pipe attached to one of the two condensate
recovery tray drain fittings.
If necessary, adapt the drain in accordance with the side chosen. In this event, block the obsolete drain hole with
the plug supplied, mounted on one of the fittings.

ELECTRICAL CONNECTIONS

The electrical connections are made on the supply terminals housed in the electrical box located on the left, behind
the lower front panel.
Follow the instructions listed on the wiring diagrams supplied with the appliance.
The average power consumption of the various elements (compressor, fan, electric heating, etc...) is listed in the
Technical Manual.
Select the power supply cable dimensions in accordance with current standards.
If fitted, the sump heating resistance (option) must have a separate power supply in order to provide compressor
heating before starting (Refer to Operating Manual).
9