Navigation System; Map Software; Information Via Satellite Signal; Operation - Mercedes-Benz Universal Media Interface Notice D'utilisation

MBA_BA_book.book Seite 31 Montag, 19. Mai 2008 12:41 12
G
Risk of accident
For safety reasons, only enter a destination
when the vehicle is stationary. Otherwise,
you could be distracted from the road and
traffic situation and cause an accident in
which you and/or others could be injured.
The Universal Media Interface calculates
route guidance to the destination without
taking account of e.g.:
• Traffic lights
• Stop and give way signs
• Parking or stopping prohibited signs
• Lane narrowing
• Other road and traffic controls and regula-
tions
The Universal Media Interface may give incor-
rect driving recommendations if the actual
road situation differs from the data on the
digital map. For example, if the traffic routing
has been changed or the direction of a one-
way road has been reversed.
For this reason, you must always observe ap-
plicable road and traffic controls and regula-
tions during your journey. Road and traffic
controls and regulations always have priority
over the system's navigation commands.
*optional

Map software

The digital maps generated by the map
software become outdated in the same
way as conventional road maps. Optimum
route guidance can only be provided by the
navigation system in conjunction with the
most up-to-date map software. Informa-
tion about new map software versions can
be obtained from any Mercedes-Benz
Service Centre.
Information via satellite signals
The navigation system must receive satel-
lite signals for route guidance. The system
may not be able to acquire satellite signals
inside multi-storey car parks or in the vicin-
ity of tall buildings or trees.

Operation

Turn ymz or slide omp to change a selection.
Press n to confirm a selection you have
made.
Press the L button to switch into the
next-highest menu level.

Navigation system

Switching on the navigation system

Note
When the navigation system is switched
on, no additional information is shown
on the display.
When using the hands-free function for
the mobile phone via the Bluetooth
terface or comfort telephony*, bear in
mind that incoming calls are displayed
exclusively in the multifunction display.
Depending on the audio system and tel-
ephone settings, you will hear an addi-
tional signal tone. (Please refer to the
audio system operating instructions and
the installation instructions for the mo-
bile phone cradle.)
1. For information on switching on the
audio system, please refer to the audio
system operating instructions.
2. Press and hold the ì button.
®
in-
31