Care And Maintenance - Hilti VC 150-6 X Mode D'emploi

CAUTION
Risk of injury by dusts that are hazardous to health! Hazardous material that has been vacuumed up can
escape if a filter element is not used.
▶ Use the vacuum cleaner only with a filter element installed.
▶ Check that the filter element is dry and that the correct type of dust bag is fitted.
7.4 Vacuuming up liquids
CAUTION
Risk of injury by dusts that are hazardous to health! Hazardous material that has been vacuumed up can
escape if a filter element is not used.
▶ Use the vacuum cleaner only with a filter element installed.
1. Check the container level monitoring system. → page 11
2. If possible, use a separate filter element for wet applications.
For information about suitable filters, consult the instructions for use for accessories → page 7.
3. After vacuuming up liquids, open the two catches.
4. Lift the suction head off the waste material container and place it on a level surface so that the filter
element can dry.
5. Empty the waste material container and use a water hose to rinse it out. Use a brush to clean the
electrodes and clean the filter element, after allowing it to dry, by wiping it off with your hand.
6. Allow the waste material container to dry.
7.5 After use of the vacuum cleaner
1. Switch off the electric tool.
2. Turn the vacuum cleaner control switch to the "OFF" position.
3. Unplug the vacuum cleaner's supply cord from the power outlet.
4. Coil up the supply cord and hang it on the hook.
5. Empty the container and clean the appliance by wiping it with a damp cloth.
6. Coil up the suction hose.
7. Store the vacuum cleaner in a secure, dry place where it is inaccessible to unauthorized users.
7.6 Emptying dry dust from the waste material container
1. Disconnect the supply cord plug from the power outlet.
2. Lift the suction head off the waste material container and place it on a level surface.
3. Then fit the suction head on to the waste material container and close the two catches.
7.7 Emptying the waste material container when no dust bag is fitted (picking up liquids)
1. Disconnect the supply cord plug from the power outlet.
2. Lift the vacuum cleaner top section away from the waste material container and place it on a level surface.
3. Grip the waste material container by the recess provided and empty it by tipping out the contents.
4. Clean the edge of the waste material container with a cloth.
5. Fit the vacuum cleaner top section onto the waste material container and close the two catches.
8

Care and maintenance

8.1 Care of the vacuum cleaner
WARNING
Electric shock hazard! Improper repairs to electrical parts can lead to serious injuries due to electric shock.
▶ Electrical parts may be repaired only by trained electrical specialists.
▶ Keep the vacuum cleaner, especially its grip surfaces, clean and free from oil and grease. Do not use
cleaning agents containing silicone.
10 English 2268128
*2268128*